47

HL: Video level is above normal and out of 

sync.

TYPE: Place where the video loss occurs.

S: Video crosspoint input (Not supported)
C: Camera control input

DATE/TIME: Date and time when the video loss state 

changes.

4.  To display the next page, press the + button.
   To display the previous page, press the – button.

Note: 

 •  To display the first page of table, press the + but-

ton while holding down the SHIFT button.

 •  To display the last page of table, press the – button

while holding down the SHIFT button.

 5.  To exit the VIDEO LOSS HISTORY table, perform 

either of the following.

 •  Select a camera. (Refer to p. 27 Camera 

Selection.)

 •  Press the MON(ESC) button.
 •  Press the EXIT button.

Note:

 •  This feature is available in only WJ-SX650 or 

WJ-SX850 because of OSD limitation.

■

Area Change

Note:

 •  The following function is available only if the 

assignments of monitor surveillance areas has 
been established through admin console. (Refer to 
the Admin Console User's Guide.)

 1.  Display "Area No" menu. (Refer to Step 1 and 2 of 

p. 41 To Recall Menu Functions.)

 2.  Select an area number by pressing the numeric 

buttons.

Area No:1        012

 Set

Area No:9        012

 Set

Note:

 •  If you have selected an area not assigned through

the admin console, operations will become 
unavailable. In this case, log out, and then log into 
the system again. (Refer to p. 26 Login and 
Logout.)

 3.  Press the F1 button. The area will be changed.

■

Operator ID

You can check your operator ID as follows.

Display "Ope ID" menu. (Refer to Step 1 and 2 of p. 41 
To Recall Menu Functions.)
Your operator ID will be displayed on the LCD.

■

Controller ID

You can check your System Controller ID as follows.

Display "Cnt ID" menu. (Refer to Step 1 and 2 of p. 41 
To Recall Menu Functions.)
Your System Controller ID will be displayed on the 
LCD.

■

System Version

You can check the system version of CPU as follows.

Display "Ver" menu. (Refer to Step 1 and 2 of p. 41 To 
Recall Menu Functions.)
The system version of CPU will be displayed on the 
LCD.

Ope ID :100      013

Cnt ID :001      014

Ver: 5.0.0.0     015