the zip-on rain canopy or mosquito netting (see 

Accessories Line).

 10•   To mount the hood, push the fittings down until 

they click, as shown in the figure.

 11•   As shown in the figure, button the hood inside the 

armrest and the backrest of the stroller.

 12•   To stretch out the hood, push the coupling 

downward. The hood can be reclined by following 

the inclination of the backrest. 

 13•   To remove the hood, you must unbutton it from 

the stroller, loosen the couplings and raise the 

tabs of the fasteners, pushing towards the inside 

of the stroller.

   BRAKE

 14•   To apply the brakes, push down with one foot the 

bars on the rear wheels, as shown in the figure. 

To release the brakes, draw the bar up. Always set 

the brakes on the stroller when it is not in motion.

   SAFETY BELT

 15•   A: Make sure that the brace is properly inserted by 

pushing as shown in the figure. B: Fasten the belt 

as shown in the figure.

 16•   To unfasten the belt, press on the buckle sides 

and pull out the waist strap.

   ADJUSTING THE FOOTBOARD

 17•   The footboard can be adjusted to three different 

positions. To lower the footboard, pull the two 

small levers downward while lowering. To lift the 

footboard, pull it up until it clicks into place. 

   ADJUSTING THE BACKREST

 18•   The backrest can be lowered to three different 

positions. To lower the backrest, pull the two 

adjustment levers towards you. To raise it, pull the 

backrest upwards.

   SWIVELLING WHEELS

 19•   To make the front wheels swivel, push down as 

shown in the figure. To fix the wheels, pull up the 

lever.

   CLOSING

   Before closing the stroller, loosen the braces if 

the hood is attached, and raise the backrest if it is 

lowered.

 20•   The stroller can be closed with one hand: pull first 

one lever up and then the other until it releases.

 21•   Grip the central handle and pull it upward until it 

closes, as shown in the figure.

 22•   Verify the correct closing of the stroller from the 

safety hook. The folded stroller can stand upright.

   TRANSPORT

 23•   The stroller can easily be carried (lock the 

swivelling front wheels) by gripping the central 

handle, as shown in the figure.

 24•   You can also use the side handle to carry it, as 

shown in the figure.

   REMOVABLE LINING

 25•   To remove the lining from the stroller, slip the 

leg divider off the safety belt from under the seat.  

Loosen the fabric sack buttons from the seat, and 

slip the sack off the hooks on the footboard.

 26•   Slip the safety belt buckles off the back of the 

backrest, and remove the straps from the two 

shoulder fasteners.

 27•   The shoulder fasteners are attached to each 

other. To remove them, slip them out through 

the openings in the fabric sack, as shown in the 

figure.

 28•   Loosen the buttons on the side of the fabric sack, 

as shown in the figure.

 29•   Loosen the safety belt on one side only, as shown 

in the figure, holding your finger under the nut. 

Slip the loosened safety belt off the stroller 

through the opening in the fabric sack, as shown 

in the figure.

 • 

 To remount the fabric sack on the stroller, follow 

the directions given above in the reverse order, 

making sure to fasten the safety belt properly.

GANCIOMATIC SYSTEM

The Ganciomatic System is the swift, practical 

system that allows one to fasten to the stroller, with 

Ganciomatic fasteners, the car seat Primo Viaggio, 

which can be bought separately and is also equipped 

with Ganciomatic System. Primo Viaggio can be 

detached from its base (which stays in the car) and 

attached to the Ganciomatic fasteners of the stroller to 

transport your child without disturbing him/her.

   STROLLER GANCIOMATIC HOOKS

 30•   To raise the Ganciomatic hooks on the stroller, 

pull the sack up at the corners of the seat and 

turn the two hooks upwards until they click into 

place.

 31•   To lower the Ganciomatic hooks on the stroller, 

pull the little lever outwards and turn the hooks 

upwards at the same time, as shown in the figure.

 PLIKO X-LITE + PRIMO VIAGGIO

 32•     To fasten the car seat to the stroller:

 - 

 set the brake on the stroller;

 - 

 remove the hood from the stroller;

 - 

 completely lower the backrest on the stroller;

 - 

 lift the footboard on the stroller to the highest 

position;

 - 

 raise the Ganciomatic hooks on the stroller;

 - 

 turn the child car seat towards the backrest on the 

stroller, lining up the front hooks on the car seat 

with the hooks on the stroller. Push the car seat 

downwards until it clicks into place.

 • 

 See the userʼs manual for instructions on how to 

detach the car seat from the stroller.

ACCESSORY LINE

 33•   Diaper-Changing Bag: Satchel with pad for 

changing babyʼs diaper. Attaches to the stroller.

 34•   Rain Canopy: Rain canopy zips onto the hood.

 35•   Mosquito Netting: Mosquito netting zips onto the 

hood.

 36•   Travel Bag: Practical duffle bag for transporting 

the stroller by plane.

CLEANING & MAINTENANCE

Your product requires only minimal maintenance. 

Cleaning and maintenance operations must be 

performed only by adults.

•   Be sure to keep all moving parts clean, lubricating 

them with light oil if necessary.

•   Dry off metal parts to prevent rusting.

•   Regularly clean the plastic parts with a damp cloth. 

Do not use solvents or similar products.

•   Brush the fabric parts to remove dust.

•   Remove any dust and sand from the wheels.

•   Protect the product against smog, water, rain and 

snow. Continued and extended exposure to sunlight 

can change the colours of many materials.

•   Store the product in a dry area.

• To wash the sack, follow the instructions below.