![background image](/i/yamaha/162252/yamaha-vmx12h-1995/h/yamaha-vmx12h-1995-101.png)
FINAL GEAR OIL LEVEL INSPECTION
OIL REPLACEMENT
Defective
valves,
cylinder head
gasket or piston is
Same as without oil
possible.
Inspect cylinder head,
valve
surfaces, or
piston crown for
Above maximum level
carbon deposits.
NOTE:
The difference between the highest and
lowest cylinder compression readings must
not vary more than the specified value.
Difference Between Each Cylinder:
Less than
98
(1
14 psi)
CHASSIS
1.
Inspect:
FINAL GEAR OIL LEVEL INSPECTION
gear oil level
Oil level low
Add sufficient oil.
By
the following inspection steps.
Final gear oil
level
visual inspection steps:
the motorcycle on
a
level area and
the oil filler cap
.
check the oil level. Correct oil
level
should be at the brim of the hole.
the oil
level is low, add sufficient oil.
the oil filler cap to specification.
Oil Filler Cap (Final Gear):
place on
its centerstand.
23
Nm
(2.3
17
FINAL GEAR OIL REPLACEMENT
1.
Place a
receptacle under the final gear case.
2.
Remove:
filler cap
plug
Drain the oil.
2-18