![background image](/i/yamaha/162252/yamaha-vmx12h-1995/h/yamaha-vmx12h-1995-233.png)
THROTTLE CABLE CYLINDER
Second step:
a.
Loosen the locknut (carburetor side).
b. Turn the adjuster (carburetor side) counter-
clockwise a
little.
c.
Turn adjuster (throttle grip side) clock-
wise
so
that the free play (throttle grip)
is
within
4
-
7
mm
(0.16
-
0.28 in).
d. Check to see if throttle valve operates at
full open.
If
not, repeat steps a
-
d.
e.
Tighten locknut (carburetor side).
f. Check to see if throttle valve operates a t
full open or full closed.
Throttle valve
fails to operate a t full open
or full closed
Perform the next step.
Third step:
to see if throttle cable installation
i s
correct.
NOTE:
Be sure that the silver throttle cable
is
po-
sitioned opposite the adjusters.
Check the position of the control cable
sliders in the throttle cable cylinder.
NOTE:
sure the open side slider (silver cable side)
falls between the three adjustment marks on
the carburetor side.
sure the closed side slider falls between
the two adjustment marks on the throttle
grip side.
the
fall
outside the adjustment
marks then the throttle
must be
replaced.
Cable adjustment mark (Open side)
Cable adjustment mark (Closed side)
5-12