![background image](/i/yamaha/162252/yamaha-vmx12h-1995/h/yamaha-vmx12h-1995-015.png)
IN SPEC TIO N A N D R EPA IR
a piece of Pl
asti
gauge® on each m ain
journal.
N O TE :
D o not put the Pl
asti
gauge® over the oil
hole in the m ain journal of the crankshaft,
install the low er half of the bearings into
the crankcase (low er) and assem ble the
crankcase halves.
N O TE :
Align the projection of the bearing w ith
the notch in the crankcase.
D o not m ove the crankshaft until the oil
clearance has been com pleted.
Tighten the bolts to specification in the
tightening sequence cast on the crank-
case.
B olt (C rankcase-M 10):
40 N m (4.0
29 ft• lb)
W ith a w asher
•
R em ove the crankcase (low er) and low er
half of the bearing.
M easure the com pressed Pl
asti
gauge® ’
w idth
on each m ain journal.
If oil clearance is out of specification,
select a replacem ent bearing.
4.M easure:
O il clearance (crank pin)
O ut of specification R eplace bearing.
(0.0008
0.0015 in
M easu rem en t step s:
D o not interchange the bearings and con-
necting rod. They m ust be installed in their
original positions, or the correct oil clear-
ance m ay not be obtained causing engine
dam age.