![background image](/i/zyxel/148476/zyxel-xs3900-48f/h/zyxel-xs3900-48f-295.png)
Chapter 36 Access Control
XS3900-48F User’s Guide
295
The following table describes the labels in this screen.
Table 140
Management > Access Control > Remote Management
LABEL
DESCRIPTION
Entry
This is the client set index number. A “client set” is a group of one or more “trusted
computers” from which an administrator may use a service to manage the Switch.
Active
Select this check box to activate this secured client set. Clear the check box if you
wish to temporarily disable the set without deleting it.
Start Address
End Address
Configure the IP address range of trusted computers from which you can manage
this Switch.
The Switch checks if the client IP address of a computer requesting a service or
protocol matches the range set here. The Switch immediately disconnects the
session if it does not match.
Telnet/FTP/HTTP/ICMP/
SNMP/SSH/HTTPS
Select services that may be used for managing the Switch from the specified trusted
computers.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.