![background image](/i/zyxel/148476/zyxel-xs3900-48f/h/zyxel-xs3900-48f-041.png)
Chapter 2 Tutorials
XS3900-48F User’s Guide
41
Note: The VLAN Group ID field in this screen and the VID field in the IP Setup screen
refer to the same VLAN ID.
3
Since the VLAN2 network is connected to port 1 on the Switch, select Fixed to configure port 1 to
be a permanent member of the VLAN only.
4
To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly,
clear the TX Tagging check box to set the Switch to remove VLAN tags before sending.
5
Click Add to save the settings to the run-time memory. Settings in the run-time memory are lost
when the Switch’s power is turned off.
2.6 Setting Port VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames are
forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames
received on that port get sent to VLAN 2.
Figure 8
Initial Setup Network Example: Port VID
1
Click Advanced Applications and VLAN in
the navigation panel. Then click the VLAN
Port Setting link.
Enter 2 in the PVID field for port 1 and click Apply to save your changes back to the run-time
memory. Settings in the run-time memory are lost when the Switch’s power is turned off.
EXAMPLE