GB

15

to each other; jumper 4-5 is located in the lower area
of the terminal board.
3. Position the wires N and 

6

6

6

6

6

 as shown in the

diagram (

see figure) and proceed with the

connection process, tightening the terminal screws
as far as possible.
4. Position the remaining wires on terminals 1-2-3
and tighten the screws.
5. Fix the power supply cable in place by fastening
the cable clamp screw.
6. Close the terminal board cover by tightening the
screws V.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the
load indicated on the appliance data plate (

see

Technical data table).
The appliance must be directly connected to the mains
using an omnipolar circuit-breaker with a minimum
contact opening of 3 mm installed between the
appliance and the mains. The circuit-breaker must be
suitable for the charge indicated and must comply with
NFC 15-100 regulations (the earthing wire must not be
interrupted by the circuit-breaker). The supply cable
must be positioned so that it does not come into
contact with temperatures higher than 50°C at any point.

Before connecting the appliance to the power
supply, make sure that:
• The appliance is earthed and the plug is compliant

with the law.

• The socket can withstand the maximum power of

the appliance, which is indicated by the data
plate.

• The voltage is in the range between the values

indicated on the data plate.

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it.
Do not use extension cords or multiple sockets.

!

 Once the appliance has been installed, the power

supply cable and the electrical socket must be
easily accessible.

!

 The cable must not be bent or compressed.

! 

The cable must be checked regularly and replaced

by authorised technicians only.

!

 The manufacturer declines any liability should

these safety measures not be observed.

*

 Only available in certain models.

TABLE OF CHARACTERISTSICS

Dimensions 
Oven HxDxW

34x41x38

Volume

53 l

Useful 
measurements 
relating to the oven 
compartment

width 42 cm  
depth 44 cm  
height 17 cm

Voltage and 
frequency

see data plate

Ceramic hob 
Front Left 
Back Left 
Back Right 
Front Right 
Max. ceramic hob 
consumption 

 
1200 W 
1800 W 
1200 W 
1800 W 
 
6000 W 

ENERGY LABEL

Directive 2002/40/EC on the label of 
electric ovens. 
Standard EN 50304 
 
Energy consumption for Natural 
convection – heating mode:

 a

Traditional mode;

 
Declared energy consumption for 
Forced convection Class – heating 
mode: 

u

 Baking mode.

This appliance conforms to the following 
European Economic Community 
directives: 2006/95/EC dated 12/12/06 
(Low Voltage) and subsequent 
amendments - 04/108/EC dated 
15/12/04 (Electromagnetic 
Compatibility) and subsequent 
amendments - 93/68/EEC dated 
22/07/93 and subsequent amendments.

2002/96/EEC 
1275/2008 (Stand-by/ Off mode)