Installing Batteries
●
Remote control uses two AAA (#7) batteries.
●
When installing the two AAA batteries, be sure to note the directions of positive and negative polarities.
●
If the batteries are low on energy, please replace both batteries so Remote will work properly.
●
Properly dispose of batteries in accordance with local legislation.
●
If the Remote is not going to be used for an extended period of time, please remove the batteries so the Remote will
not become damaged.
USE:
●
To use the Remote, you must be within 16 feet and point it towards the Indicator light on top of the Driver Winbot.
●
Do
NOT
use the Remote to try and force the Winbot over an obstacle on the window as it may cause the two Winbots
to lose their magnetic grip on each other and allow the Winbots to fall from the window and cause personal or
property damage.
●
In some instances, other wireless products within the area may interfere with the Remote sending a signal to the
Winbot, in that case, you will have to move closer to the front of the Winbot for it to work properly.
●
Do
NOT
place the Remote in a hot place or in direct Sun light as the Remote may become damaged.
●
Do
NOT
expose the Remote to water or allow debris to become lodged around the buttons or inside when replacing
the batteries as this could cause damage to the Remote.
3.
Remote Control
4. Charger/Power Pack
Placement of Charger
●
Do
NOT
touch
Charger
/
Power Pack with
WET
hands.
●
The Power Pack can be used in most locations to plug in to a receptacle and the
Driver Unit
for
charging
the
battery
.
●
The Supply Cord should
NOT
be
placed close to edge of table or
counter where a child might grasp
the cord and pull the unit down
upon themselves.
●
Do
NOT
charge Winbot next to a
sink because a shock hazard
exists.
Enjoy Smarter Life!
11
