![background image](/i/ecovacs/152466/ecovacs-winbot-w5s/h/ecovacs-winbot-w5s-016.png)
16
●
Reference Cleaning Winbots and Cleaning the Pads on page 17.
Cleaning After Use
NOTE
:
At anytime while the Winbots are cleaning the Window, you may use the
Remote
. Press the
Pause
button on the
Remote
and the Winbots will enter
the
Pause Mode
. Then press one of the
arrow
buttons to drive the Winbots
in the direction that you want. You may then press
Auto
on the
Remote
to
return control of the cleaning back to the Winbot.
●
When the Winbots are finished cleaning the Window, they should return to
where you placed them to start the cleaning process.
●
Should the Winbots not be reachable to remove from the Window, use the
Remote
to bring the Winbots back within easy reach for removal.
●
When using the W553 Driver Winbot, first, unplug the Power Pack from the
wall receptacle and then unplug the Supply Cord from the Driver Winbot.
●
Grasping both Winbots, place Driver Winbot on
the Inside of the Window and the Follower Winbot
on the Outside of the window below the other and
gradually bring them together until you feel the
magnetic attraction.
●
Once the two Winbots are opposite each other on the Window, turn the
Follower
handle clockwise until the
Indicator
light turns
BLUE
on
the
Driver
●
If you are using the Safety Line because the window is more than 10 feet off the
ground, reach for the
YELLOW POD
on the floor and place it by the Window
Housing while you close the Window on the Security Line.
●
Once the
YELLOW POD
is trapped by the closed Window, press the
START
button again and the Winbots will start to clean the Window.
M
in
M
ax
Min
Max
●
If using the Safety Line and the Winbots are within easy reach,
grasp the
YELLOW POD
in one hand and open the window. Placing the
YELLOW POD
on the floor, place your foot on the Security Line in front of the
POD
. This will
keep the Outside Winbot from falling very far should you loose grip while
separating from the Inside Winbot and bringing in side.
●
Grasp both Winbots by their handles and slide one Winbot away from the
other until they have
NO
magnetic pull. Move the Inside Driver Winbot away
from the window and bring the Follower Winbot in from Outside.
●
Do
NOT
allow the two Winbots to come together.
●
Turn the Winbots so the bottoms are facing upwards so water and dirt will
NOT fall off onto the floor or furniture.
pull the plug
pull the plug
Indicator Light
Indicator Light