![background image](/i/ecovacs/152466/ecovacs-winbot-w5s/h/ecovacs-winbot-w5s-007.png)
Power Supply for the W inbot
Min
Max
●
●
●
●
●
The W555 Winbot's power is from a Lithium rechargeable battery and only
accompanying ECOVACS' charger may be used.
W555 can also be used with Charger as a continuous power source without
creating a problem. But before applying the Winbots to window, you must
plug the Charger into a receptacle by the window and plug the Supply Cord
into the Driver receptacle and move the Driver Winbot to the furthermost
corner of the window to see that the Power Pack is not being pulled from the
receptacle and the Power Supply Cord is
NOT
being strained.
Do
NOT
use the Charger/Power Pack if the supply cord becomes damaged,
Call
or visit our Web Site for the nearest Service Center
to send theCharger/Power Pack for repair.
Do
NOT
twist or pinch the supply cord to avoid damage to the insulation.
Keep supply cord away from warm/hot places or sharp edges to avoid
damage to the insulation.
Local service hotline
●
In order to charge the W555 Driver Winbot, the switch
MUST
be in the
ON
position
.
The
Power
Pack
light
will
glow
RED,
indicating the battery
needs charged, and when fully charged, the light will glow
GREEN.
When
the battery is fully charged, the Power Pack will reduce the power so as not to
hurt the battery.
●
●
Turn both W555 Winbots
OFF
after each use to save the batteries.
The
W553
Winbot
'
s
power
source
is
from
the
accompanying
Power
Pack
.
In
order
to
use
the
W553
Winbot
to
clean
a
window
,
you
must
plug
the
accompanying
Power
Pack
into
a
220
volt
receptacle
by
the
window
and
plug
the
male
plug
at
end
of
Supply
Cord
into
the
Driver
Winbot
.
●
Do
NOT
touch the Charger/Power Pack or Winbot with
WET
hands while
plugged into the receptacle nor while charging the W555 Winbot.
Min
Max
Enjoy Smarter Life!
7
●
With the plug end of the Power Supply Cord in hand, there is
NO
shock
hazard
to
you
,
move
to
the
furthermost
corner
of
the
window
and
check
to
make
sure
the
Power
Pack
is
not
being
pulled
from
the
receptacle
and
the
Power
Supply
Cord
is
NOT
being
strained
.
●
With
Power
Pack
supply
line
attached
to
the
Driver
Unit
,
turn
the
unit
ON
and the Winbot will clean your window.
●
Turn the W553 Follower Winbot
OFF
after
each
use
to
save
the
batteries
.
The
W553
Driver
Winbot
does
not
contain
a
battery
.
Correct
Min
Max