15

GB

The timer begins counting down immediately. A buzzer 
sounds for approximately 1 minute and the cooking 
zone switches off when the set programme has 
finished.
Repeat the above procedure for each hotplate you 
wish to programme.

Using multiple programmes and the display

If one or more hotplates are programmed, the display 
will show the data for the hotplate with the least time 
remaining, and the light corresponding to the position 
of the hotplate will flash. The lights corresponding to 
the other hotplates programmed will be switched on.
To visualise the time remaining for the other 

programmed hotplates, press the 

 button 

repeatedly: the time remaining for each hotplate will be 
shown sequentially in a clockwise order, starting from 
the front left hotplate.

Changing the programme

1. Press the 

 button repeatedly until the duration 

you wish to change is shown.

2. Use the 

 buttons to set the new 

duration.

3. Confirm by pressing the 

 button.

To cancel a programme, follow the above instructions. 

At step 2, press the 

-

 button: the duration decreases 

progressively until it reaches 0 and switches off. The 
programme resets and the display exits programming 
mode.

Timer

The hob must be switched on.
The timer can be used to set a duration up to 99 minutes.

1. Press the 

 programming button until the timer 

indicator light is illuminated 

.

2. Set the desired duration using the 

-

 and 

+

buttons.

3. Confirm by pressing the 

 button.

The timer begins counting down immediately. When 
the time has elapsed, a buzzer will sound (for one 
minute).

Control panel lock

When the hob is switched on, it is possible to lock the 
oven controls in order to avoid accidental changes 
being made to the settings (by children, during 

cleaning, etc.). Press the 

 button to lock the control 

panel: the indicator light above the button will switch 
on.
To use any of the controls (e.g. to stop cooking), you 

must switch off this function. Press the 

 button for a 

few moments, the indicator light will switch off and the 
lock function will be removed.

Switching off the hob

Press the button 

 to switch off the appliance - do not 

rely solely on the pan sensor.
If the control panel lock has been activated, the 
controls will continue to be locked even after the hob is 
switched on again. In order to switch the hob on again, 
you must first remove the lock function.

“Demo” mode

It is possible to set the hob to a demonstration mode 
where all the controls work normally but the heating 
elements do not switch on. To activate the “demo” 
mode the hob must be switched on, with all the 
hotplates switched off.

•  Press and hold the 

+

 and 

-

 buttons 

simultaneously for 6 seconds. When the 6 seconds 
have elapsed, the ON/OFF and CONTROLS 
LOCKED indicator lights will flash for one second. 

Release the 

+

 and 

-

 buttons and press the 

button;

•  The display will show the text DE and MO and the 

hob will be switched off.

•  When the hob is switched on again it will be set to 

the “demo” mode.

To exit this mode, follow the procedure described 
above. The display will show the text DE and OF and 
the hob will be switched off. When it is next switched 
on, the hob will function normally.

Practical advice on using the appliance

!

 Use cookware made from materials which are 

compatible with the induction principle (ferromagnetic 
material). We especially recommend pans made 
from: cast iron, coated steel or special stainless 
steel adapted for induction. Use a magnet to test the 
compatibility of the cookware.