![background image](/i/infiniti/150404/infiniti-m35-2007-m45-2007/h/infiniti-m35-2007-m45-2007-123.png)
1. To begin, push and hold the 2 outer
HomeLink
buttons (to clear the
memory) until the indicator light
q
A
blinks (after 20 seconds). Release
both buttons.
2. Position the end of the hand-held
transmitter 1-3 inches away from the
HomeLink surface.
3. Using both hands, simultaneously
push and hold both the HomeLink
button you want to program and the
hand-held transmitter button.
DO NOT release the buttons until step
4 has been completed.
4. Hold down both buttons until the indi-
cator light on HomeLink
flashes,
changing from a “slow blink” to a
“rapid blink”. This could take up to 90
seconds. When the indicator light
blinks rapidly, both buttons may be
released. The rapidly flashing light in-
dicates successful programming. To
activate the garage door or other pro-
grammed device, push and hold the
programmed HomeLink button - re-
leasing when the device begins to ac-
tivate.
5. If the indicator light on HomeLink
blinks rapidly for two seconds and
then turns solid, HomeLink
has
picked up a “rolling code” garage
door opener signal. You will need to
proceed with the next steps to train
HomeLink , completing the program-
ming may require a ladder and an-
other person for convenience.
6. Push and release the program button
located on the garage door opener’s
motor to activate the “training mode”.
This button is usually located near the
antenna wire that hangs down from
the motor. If the wire originates from
under a light lens, you will need to re-
move the lens to access the training
button.
NOTE:
Once you have pushed and released the
training button on the garage door open-
er’s motor and the “training light” is lit,
you have 30 seconds in which to perform
step 7. For convenience, use the help of a
SIC3182
SIC3183
Instruments and controls
2-53
w
06.3.30/Y50-D
X