![background image](/i/infiniti/150404/infiniti-m35-2007-m45-2007/h/infiniti-m35-2007-m45-2007-251.png)
LANE DEPARTURE WARNING
SYSTEM OPERATION
The LDW system has an automatic mode
and manual mode.
In the automatic mode, the LDW system
automatically turns on when the push-
button ignition switch is turned to the ON
position. The LDW system ON indicator
q
2
located on the LDW switch
q
1
illuminates,
indicating that the system is on.
To cancel the LDW system, push the LDW
switch
q
1
to turn off the LDW system ON
indicator
q
2
. To turn on the system, push
the LDW switch
q
1
again.
In the manual mode, the LDW system will
be off when the ignition switch is pushed
to the ON position. The LDW switch must
be pushed to turn on the system.
To change modes, push and hold the LDW
switch
q
1
for more than 4 seconds when
the LDW system ON indicator
q
2
is off.
Both chime sounds and blinking of the
LDW system indicator inform you that the
mode change has been completed.
When the vehicle approaches either the
left or the right of the traveling lane while
driving over approximately 45 MPH (72
km/h), the LDW indicator
q
3
on the in-
strument panel flashes and a chime
sounds to alert the driver.
When you use the lane change signal and
change your traveling lane, the LDW
system does not warn you until about 2
seconds after the lane change signal is
turned off.
When the vehicle speed lowers to less
than approximately 45 MPH (72 km/h),
the LDW system does not warn you.
SIC2554
SSD0411
Starting and driving
5-17
w
06.3.30/Y50-D
X