![background image](/i/infiniti/150404/infiniti-m35-2007-m45-2007/h/infiniti-m35-2007-m45-2007-153.png)
Repeat the above procedure to adjust
the right mirror position and store in
the selected memory.
O
When the driver’s seat, outside mirror
and steering column are not in the
memorized
position,
the
outside
mirror will move with the initial tilt-
down angle, if the reverse tilt-down
position is stored.
Linking Intelligent Key to a stored
memory position
The Intelligent Key can be linked to a
stored memory position with the following
procedure.
1. Follow the steps for storing a memory
position.
2. While the indicator light for the
memory switch being set is illumi-
nated for 5 seconds, push the
button on the Intelligent Key. The
indicator light will blink. After the indi-
cator light goes off, the Intelligent Key
is linked to that memory setting.
Push the ignition switch to the LOCK posi-
tion and press the
button on the In-
telligent Key. The driver’s seat, steering
wheel and outside mirrors will move to
the memorized position.
Confirming memory storage
O
Push the ignition switch to the ON po-
sition and push the SET switch. If the
main memory has not been stored, the
indicator light will come on for ap-
proximately 0.5 seconds. When the
memory has stored in position, the in-
dicator light will stay on for approxi-
mately 5 seconds.
O
If the battery cable is disconnected, or
if the fuse opens, the memory will be
canceled. In this case, reset the de-
sired position using the previous pro-
cedure.
O
If optional Intelligent Keys are added
to your vehicle, the memory storage
procedure to switch 1 or 2 and linking
Intelligent Key procedure to a stored
memory position should be performed
again for each Intelligent Key. For ad-
ditional Intelligent Key information,
see “Key (Intelligent Key)” earlier in
this section.
Selecting the memorized position
1. Set the selector lever to the P (Park)
position.
2. Push the ignition switch to the ON po-
sition.
3. Push the memory switch (1 or 2) fully
for at least 1 second.
The driver’s seat, steering column and
outside mirrors will move to the
memorized position with the indicator
light flashing, and then the light will
stay on for approximately 5 seconds.
SYSTEM OPERATION
The automatic drive positioner system will
not work or will stop operating under the
following conditions:
O
When the vehicle speed is above 4
MPH (7 km/h).
O
When the adjusting switch for the driv-
er’s seat and steering column is
turned on while the automatic drive
positioner is operating.
O
When the memory switch 1 or 2 is not
pushed for at least 1 second.
O
When the seat has already been
moved to the memorized position.
O
When no seat position is stored in the
memory switch.
O
When the engine is started while mov-
Pre-driving checks and adjustments
3-27
w
06.3.30/Y50-D
X