![background image](/i/karcher/166773/karcher-b-140-r-bp-pack-dose/h/karcher-b-140-r-bp-pack-dose-028.png)
-
11
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
Only use accessories and spare parts
which have been approved by the man-
ufacturer. The exclusive use of original
accessories and original spare parts
ensures that the appliance can be oper-
ated safely and trouble free.
At the end of the operating instructions
you will find a selected list of spare
parts that are often required.
For additional information about spare
parts, please go to the Service section
at www.kaercher.com.
Faults without display on the console
Fault
Remedy
Appliance cannot be started
Insert battery plug.
Set main switch to “1”.
Check fuse F1, replace if required. *
Check battery; charge it if required.
Insufficient water quantity
Check fresh water level, refill tank if necessary.
If necessary, fill the fresh water tank completely to ventilate the lines.
Check that the hose coupling to drain the fresh water is connected.
Open the ball tap.
Check the set water volume in the user's menu.
Check hoses for blockages; clean if required.
Clean the fresh water filter.
Insufficient vacuum performance Set the suction turbine to the max. suction in the user's menu (shut low noise operation off).
Clean the seals between dirt water reservoir and cover and check for tightness, replace if required.
Clean the fluff filter.
Clean the vacuum lips on the vacuum bar, replace if required
Check suction hose and the vacuum bar for blockages; clean if required.
Check the suction hose for tightness; replace if required.
Check if the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Insufficient cleaning result
Set/ adjust contact pressure.
Check the brushes for wear (bristle length at least 10 mm), replace if required.
Check the set brush speed (FACT) in the user's menu, select Power Clean if applicable.
Brushes do not turn
Reduce contact pressure.
Check if foreign matters block the brushes; remove foreign matter if required.
Optional beacon lamp is not
functioning
Check fuse F4, replace if required. *
* The fuses are located in the flat insertion sockets on the wiring plate and can be accessed by opening the front panel.
Warranty
Accessories and Spare
Parts
28
EN