![background image](/i/kawasaki/160046/kawasaki-er5-2004/h/kawasaki-er5-2004-046.png)
2-6 FUEL SYSTEM
Throttle Grip and Cables
•
Check that the throttle pulley [A] stops against the idle
adjusting screw [B], with the throttle grip released and
stops against the carburetor stopper with the throttle grip
opened.
•
Turn the handlebar from side to side while idling the en-
gine.
If idle speed varies, the cable may be poorly routed or
damaged.
WARNING
Operation with an improperly adjusted, incorrectly
routed, or damaged cable could result in an unsafe
riding condition.
Throttle Cable Inspection
•
Remove both ends of the throttle cables.
•
With the throttle cable disconnected at both ends, the ca-
ble should move freely [A] within the cable housing.
○
If cable movement is not free after lubricating, if the cable
is frayed [B], or if the cable housing is kinked [C], replace
the cable.
Throttle Cable Lubrication
Whenever the throttle cables are removed, lubricate the
throttle cables as follows:
•
Apply a thin coating of grease to the throttle cable lower
ends [A].
•
Lubricate the throttle cable with a penetrating rust in-
hibitor.