![background image](/i/line-6/137602/line-6-spider-valve-mkii-hd100-spider-valve-mkii-112-spider-valve-mkii-212/h/line-6-spider-valve-mkii-hd100-spider-valve-mkii-112-spider-valve-mkii-212-015.png)
Editing
3•3
Gate
If you press the right arrow from the Reverb screen, you’ll see the Gate screen. Your Gate
Mode choices are Off (Gate is disabled), Gate (a standard noise gate), NR (a frequency
dependent noise reduction) or Gate+NR (both Gate+NR together). You can also adjust
Threshold and Decay settings. Gate parameters are saved with the individual preset.
Boost
We’ve included a new Boost with Spider Valve MkII, which is the next Edit Mode screen
to the right of Gate. Boost has 3 parameters: Pre, which lets you set the amount of Boost
before your signal hits the Amp Model, Post, which lets you set boost level after the Amp
Model, and Active, where your choices are On or Off. Boost is also saved per preset.
Vol
Press right arrow from the Boost screen to see Vol. If you use an FBV or expression pedal
to control Volume, you can set its parameters for Min (the minimum volume for heel
down), Max (the maximum volume for toe down) and Routing, which routes the volume
pedal pre or post Amp Model. Vol is saved per preset.
Loop
If you press right arrow from the Vol screen you’ll arrive at the Loop screen. This screen
is dedicated to Loop routing, and is saved per preset. Pre routes your loop audio before the
Amp Model; Post routes it after the Amp Model.
MIDI
Press right arrow from Loop to set your MIDI Channel and Output mode (Out or Thru).