![background image](/i/uni-t/145436/uni-t-utm-1204a-ut204a/h/uni-t-utm-1204a-ut204a-003.png)
UT204A is a 3 3/4-bit AC/DC digital clamp
meter (hereinafter referred to as clamp m
eter
)
with stable performance, safety and reliability. As
a special electrician's instrument with excellent
performance, machine circuit is designed on the
basis of large-scale integrated circuit double-
integer A/D converter with full-range overload
protection circuit and specific appearance design.
Clamp meter can be used to measure AC/DC
voltage, current, resistance, diode,c
ircuit O
N/OFF,
capacitance, frequency and temperature, etc.
The usage manual includes related safety
information and warning prompt, etc. Please read
content carefully and abide by all warnings and
notices strictly.
I.INTRODUCTION
Warning: Please read
Rules for Safe
Operation c arefully b efore u sage o f c lamp m
eter.
II.UNPACKING INSPECTION
Please open the package box and take instrument
out. Please check if following items are deficient or
damaged or not.
1 book
1 pair
1 probe
1. Usage manual
2. Probe
3. Temperature probe
4. Guarantee certificate 1 sheet
Please contact your supplier instantly if any item
is deficient or damaged.
III.RULES FOR SAFE OPERATION
Please pay attention to
Warning Sign
and Cautionary Words
. Warning refers to
possible danger to user, instrument or measured
equipment.
The instrument shall be designed and
produced according to GB4793 Safety
Requirements of Electronic Measuring Instrument,
IEC 61010-1 and IEC 1010-2-032 Safety Standard
to meet safety standards of duplex insulation, over-
voltage CAT II 600V, CAT III 300V and pollution
level
Protection ability may be weakened or lost if
failing to use clamp meter according to related
operation instructions.
1. Please inspect clamp meter and probe before
use to avoid damage or abnormal use. Please
do not use the clamp meter again if probe or
shell insulation is damaged obviously with LCD
display failure or clamp meter cannot operate
normally.
2. It is strictly prohibited to use clamp meter before
covering rear cover and battery cell to avoid
electric shock.
3. Fingers cannot exceed probe forehand during
measurement. Do not touch nude electric wires,
connector, unused input end or circuits during
measurement to avoid electric shock.
4. Function switch must be in correct position
before measurement. It is strictly prohibited to
change gears during measurement to avoid
damage of clamp meter.
5. Do not exert at least 600V between terminal of
clamp meter and grounding to avoid electric