![background image](/i/uni-t/145436/uni-t-utm-1204a-ut204a/h/uni-t-utm-1204a-ut204a-008.png)
ºÚ
ºÚ
ºì
ºì
Figure 6
To gain excellent measured result by separating
element from circuit.
To disconnect probe and measured circuit then
remove probe from input end after all
measurement operations.
5. Conductance detection ( ) (shown in Figure 7)
Warning: Be sure to cut off circuit power and
discharge residual charge of all capacitors
before load connection.
To set knob.
Please place function knob to
measurement gear.
To select functions.
To select conductance detection by pressing
SELECT key;
To connect load.
ºì
ºì
ºÚ
ºÚ
Figure 7
Buzzer will ring if measured resistance during
conductance test is less than 10
. It can ring or
not ring if measured resistance exceeds 10
.
To disconnect probe and measured circuit then
remove probe from input end after all
measurement operations.
6. Capacitance measurement ( ) (shown in
Figure 8)
Warning: Be sure to cut off circuit power and
discharge residual charge of all capacitors
before load connection.
To set knob.
Please place function knob to
measurement gear.
To select functions.
To select capacitance detection by pressing
SELECT key;
To connect load.