![background image](/i/uni-t/145436/uni-t-utm-1204a-ut204a/h/uni-t-utm-1204a-ut204a-006.png)
Note: Automatic shutdown function will be
cancelled by pressing SELECT key for wake-up
under sleeping status.
5.Buzzer
Buzzer will beep if pressing any effective function
key under any measurement gear. It will not ring
if the key is invalid. Buzzer will issue 5 warning
voices continuously about 1 minute before
automatic shutdown. It also will issue a long-term
voice before shutdown.
6.Key validity
Note all key operations are valid for any gear. As
shown in following form, corresponding operation
functions cannot be selected or instruments
under sleeping status cannot be wakened up
until effective key operation.
Key
Hz
SELECT
N/A
N/A
N/A
REL
HOLD
VIII. MEASUREMENT
INSTRUCTIONS
1. DC voltage measurement ( ) (shown in
Figure 3)
Warning: Clamp meter cannot be used for
conductive article of which voltage exceeds
AC/DC 600V.
To set knob.
Please place function knob to
measurement
gear.
To select key functions.
To set measured DC voltage to initially set value.
Initially set automatic range can be set to
relative
range by pressing REL
key.
To connect load.
ºì
ºì
ºÚ
ºÚ
V
V
To disconnect probe and measured circuit then
remove probe from input end after all
measurement operations.
Figure 3
2. AC voltage measurement ( ) (shown in
Figure 4)
Warning: Clamp meter cannot be used for
conductive article of which voltage exceeds
AC/DC 600V.
* To set knob.
Please place function knob to
measurement
gear.