![background image](/i/zelmer/152639/zelmer-1766-b/h/zelmer-1766-b-045.png)
45
Disassemble the juice extractor before first usage and
clean the parts in contact with processed product.
Preparations for operation (disassembling,
assembling)
Place the juice extractor near the socket on the firm,
clean and dry surface.
Pull down the locking bar
(6)
so that the tracks moved out
of grooves of the lid
(5)
from position
1
to position
2
.
Take the pusher
(7)
out and remove the lid
(5)
. Then
remove the bowl
(2)
including the insert
(3)
and filter
(4)
.
Finally, disassemble the insert
(3)
from the bowl
(2)
.
Wash the disassembled parts (apart from the motor)
carefully in hot water and wash-up liquid. You can clean
them in dishwasher in max temp. 60ºC (
apart from the
motor and filter)
. After drying carefully start assembling
the clean parts
.
Align the bowl
(2)
to the motor
(1),
so that the 4
buckles from the upper part of the motor
(1)
were placed inside the 4 grooves in the bottom
of the bowl
(2)
.
1
2
Align the insert
(3)
to the bowl
(2)
so that the fin
(e)
of the insert
(3)
is placed in the cutting of the bowl
(2)
over the juice spout.
Put the filter
(4)
inside and check if it is well mounted and
rotates easily.
Put the lid
(5)
so that the fin
(e)
of the insert
(3)
was placed in
the cutting of the lid
(5)
.
Pull the locking bar
(6)
up, so that the rolls moved into grooves
of the lid
(5)
from position
2
to position
1
( you will hear
a characteristic clicking sound).
Put the pusher
(7)
into the chute so that the V-shaped hole
was put on the knife inside the chute.
We call your attention to proper
assembling. The fin
(e)
of the insert
(3)
should be in the same line as the
cutting on the bowl
(2)
and the
cutting in the lid
(5)
.