46

581-002_v01

CUP (12)

Made of transparent material is used as a container when 

mixing adapter is used.

OPERATION WITH MIXING ADAPTER (Fig. F)

You can use the mixing adapter for:

mixing liquids,

●

crumbling boiled vegetables and raw, soft fruit,

●

preparing different mayonnaise and pastes,

●

preparing soups for infants.

●

crushing ice (metal adapter only).

●

You can assemble the adapter after moving the cover.

1

 Gently  press  the  bolt  and  slide  towards  the  direction 

shown in the figure.

2

 Insert the threaded part into the motor casing hole and 

screw it turning right until you feel the refusal.

Inadequate screwing of the mixing adapter can 

result in clutch damage or the adapter damage.

3

 Put the adapter into the processed product and switch 

the mixer on.

OPERATION WITH STAND INCLUDING TURNABLE BOWL 

(Fig. G)

The stand with assembled motor part makes the operation 

with whisks or mixers easy, as the user does not have to hold 

the device.

The stand head driver automatically makes the head move 

pendulum-like  and  simultaneously  turns  the  bowl  with  the 

mixed product.

You can use the stand with specially prepared whisks and 

mixers only. The device equipped with stand includes also 

one mixer and one whisk with toothed bar.

1

 Insert  the  mixers  or  whisks  into  the  motor  casing 

(as described above).

2

 Assemble the drive in the stand head after moving the 

cover (like during assembling the adapter) the following way: 

Insert the drive fasteners (which are located near the holes 

for whisks assembling) under the stand head fastener.

3

 Turn the control clamp to the limit in such a way that the 

hand is positioned vertically.

4

 Press the fastener button and simultaneously deflect the 

stand head with the motor part back.

5

 If the bowl with products a bit up and then insert it on the 

three insertions and place it at the stand base.

6

 Place the stand head with the motor part in horizontal 

position (you will hear the clicking sound of fastener blocking 

clamps).

Start-up the mixer with the switch lever and it will make 

●

the bowl turn and the head with drive move pendulum-

like.

  Never block or stop the oscillatory movement 

during operation. It may cause damage to the 

housing.

The  manufacturer  does  not  accept  any  liability  for  any  damages 

resulting from unintended use or inappropriate handling.

The manufacturer reserves his rights for modifying the product any 

time in order to adjust it to law regulations, norms, directives, or due 

to construction, trade aesthetic or other reasons, without notifying it in 

advance.

After operation  

(Fig. H)

1

 Turn off the mixer.

2

 Pull the plug out.

Depending on assembled equipment:

3

 Push the whisks or mixers out with a pushing button.

4

 Disassemble the liquidizing disc from the whisk.

5

 The mixing attachment should be disassembled in a way 

opposite to its installation.

6

 Deflect the stand head with the motor part back.

7

 Turn  the  clamp  knob  in  counter  clockwise  direction  as 

much as possible and put the motor out of the head fasteners.

8

 Wind the power cord on the motor part and put the last 

winding under the insert.

Cleaning and maintenance

Remember to unplug before clearing and maintenance.

Clean  the  whisks  and  mixers  with  warm  water  with 

●

cleaning agents.

Wash the mixing attachment by using it with clean, warm 

●

water (after plugging the mixer in).

Clean  the  cogged  rim  of  rotational  bowl  with  dishes 

●

cleaning brush.

Do not clean the mixing attachment in a dishwasher.

●

Turn the bowl upside down after cleaning and pour out 

●

the water, which could remain under the cogged rim.

Dry the mixer equipment after cleaning and store in dry 

●

place.

Clean  the  motor  or  stand  casing  with  dump  cloth  and 

●

then dry it.

Ecology – environment protection

Each user can protect the natural environment. 

It is neither difficult nor expensive. In order to 

do it: Put the cardboard packing into recycling 

paper  container,  Put  the  polyethylene  (PE) 

bags into container for plastic.

When worn out, dispose the appliance to particular disposal 

centre, because of the dangerous elements of this appliance, 

which can be hazardous for natural environment.

Please do not dispose into domestic waste disposal!!!