36
TS1200-001_v01
Maintenance and operation
of the toaster
(Figure B)
Place the toaster on a dry, flat surface away from
●
potential heat sources (heating plates/panels, cookers,
ovens, etc.).
Insert the plug into an AC wall outlet.
●
1
Insert the bread, bun or half rolls into the holes for bread.
Make sure they are not too large or too thick to fit in the holes
for bread.
2
By means of the regulator to control the degree of
toasting
(6)
, select the desired browning setting. The range
of browning settings is scaled from a position of less than
1 (0.5) (lightly toasted) to more than 6 (6.5) (highly toasted).
When you turn on and use the toaster for the
first time, select the setting No. 3. Different
types of bread, and personal preferences may
require different settings.
3
To insert bread into the toaster, push down the toasting
lever
(5)
until it is locked. This starts the toasting cycle.
Toasting cycle can be stopped at any time by pressing
●
a button
– cancel/stop the toasting
(7)
.
In order to facilitate the removal of smaller items, such as
●
round cakes, muffins, etc., lift the lever
(5)
upwards until
stop – above the starting position.
If it is found that the bread is not browned enough, it can
●
be retoasted. Choose a light toasting (set the knob in
position 12) and then press down the toasting lever
(5)
.
Be careful not to burn toasts.
4
When the toasting cycle is finished, toasting lever
(5)
automatically rises to the initial position. Remove the toast
paying attention not to touch any hot surface.
In the case where the bread gets stuck in the toaster, press
the button
– cancel/stop toasting and remove plug from
wall outlet. Allow the toaster to completely cool before careful
loosening bread so not to damage the heating elements.
Additional features
FROZEN BREAD TOASTING
For frozen bread toasting, place it into holes for bread
(1)
,
select the desired degree of toasting. To leave the bread into
the toaster, push down the toasting lever
(5)
until it is locked
and then press the button
– frozen bread toasting,
located at the top of the toaster (button lights up).
Frozen bread toasting takes more time than
thawed bread.
Never cover the device when connected to a current
●
or is hot.
Do not load the device with bread that contains sugar,
●
jam or other additives.
Bread to be baked should be sized for your toaster,
●
it should not protrude above the opening for bread
loading and should not be too thick or too long in order
not to block nor to jam the toast lift.
Do not use harsh, abrasive or caustic cleaning agents
●
to clean the device.
Suggestion
Information on the product and suggestions
for its use
Do not use the appliance outdoors.
●
Never use the device against its intended purpose. The
●
device is intended for domestic use only.
Before making the first piece of toast, run the toaster
●
once or twice without any food item at the maximum
degree of heat. This will significantly eliminate the
“new” smell of the device.
When you turn on and use the toaster for the first
●
time, as far as heating up the heating elements may
have a slight smell of ‘burnt’. This is not a threat nor
any evidence of malfunction of the product. The smell
should disappear after repeated use.
Technical parameters
The toaster technical parameters are included at the name
plate. The toaster is I class appliance, equipped with
supplying cord and plug with grounding.
ZELMER toaster meets the requirements of effective standards.
The appliance meets the requirements of the following
directives:
Low voltage appliance (LVD) – 2006/95/EC.
–
Electromagnetic compatibility (EMC) – 2004/108/EC.
–
The appliance was marked by the CE sign on the rating label.
Composition of the toaster
(Figure A)
1
Variable width holes for bread loading
2
Button
– sided toasting of buns, bagels
3
Button
– frozen bread toasting
4
Button
– reheating of bread
5
Toasting lever
6
Degree of toasting control knob
7
Button
– cancel/stop the toasting
8
Crumb tray
9
Grill for toasting
10
Place for the cord storage (below)
