![background image](/i/zelmer/152504/zelmer-zwt-5014ab-zwt-6024ab/h/zelmer-zwt-5014ab-zwt-6024ab-029.png)
29
WT-001_v01
EN
Dear Customers!
Congratulations on your choice of our appliance, and
welcome among the users of Zelmer products.
In order to achieve best possible results we recommend
using exclusively original Zelmer accessories. They have
been specially designed for this product.
Please read these instructions carefully. Pay special attention
to important safety instructions to avoid accidents and/or
damage to the appliance. Keep this User’s Guide for future
reference.
Important safety instructions
Read the entire instruction manual before operating the
●
appliance.
The appliance is intended for household use only.
●
The warranty conditions change if the appliance is used
in gastronomic business.
Do not unplug by pulling on cord.
●
The cord cannot touch hot surfaces.
●
Do not start the appliance, if its cord or its housing is
●
visibly damaged. In such a case, take the appliance for
repair to a qualified service center.
If the supply cord is damaged, it must be replaced by
the manufacturer, a service agent or a qualified person
in order to avoid a hazard.
The appliance can only be repaired by qualified service
personnel. Improper servicing may cause a serious
hazard to the user. In case of defects please contact
a qualified service center.
The cooker hood is used to extract cooking fumes to
●
the outside. It should be connected to an appropriate
ventilation duct (do not connect to working chimney
ducts, smoke ducts or exhaust fume ducts).
The appliance should be installed at the height of at
●
least 650 mm from the electric cooking plate and at least
700 mm from a gas cooker.
Do not leave an open flame under the cooker hood. Set
●
the minimal flame while removing pots from the gas ring.
Dishes prepared using fats should be constantly
●
supervised, as overheated fat may easily catch fire.
Clean the cooker hood anti-grease filter at least every
●
2 months. A filter saturated with grease is flammable.
Unplug the appliance before each cleaning operation,
●
before replacing the filter or starting any repair works.
If there are other appliances with non-electric supply
●
(e.g. liquid fuel stoves, flow heaters, therms) in the room
apart from the hood, a sufficient ventilation (air intake)
should be provided. Safe exploitation is possible if
during the simultaneous operation of the cooker hood
and combustion appliances dependant on the air inside
the room, the underpressure in the place where those
appliances are located amounts to 0.004 milibar at the
highest (this does not apply if the cooker hood is used as
the odor absorber).
Anti-grease filters as well as active-coal filters should be
●
cleaned or replaced according to the recommendations
of the manufacturer or more often, if they are intensively
used (more than 4 hours a day).
Always check if the flame does not exceed the pot, as
●
this causes undesirable energy losses and a dangerous
heat concentration. Use the cooker hood only for its
intended use.
Do not wash under running water. Do not immerse the
●
appliance and the cord into water.
Do not use abrasive detergents such as emulsions,
●
cream cleaners, polishes, etc. to clean the housing. They
may remove the graphic information symbols such as:
scales, marks, warning signs etc.
The use of accessories not recommended by the
●
manufacturer may cause damage to the appliance.
This appliance is not intended for use by persons
●
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
●
play with the appliance.
Make sure that the above instructions have been
understood.
Technical Parameters
Features
Hood type
ZWT5014AB/ZWT6024AB
Voltage
230 V~ 50 Hz
Fan motor
1
Lighting
1 x 25 W
Speed settings
3
Width [cm]
50/60
Depth [cm]
31–47
Height [cm]
19
Outlet [
∅
mm]
120
Efficiency – [m
3
/h]
max 400
Energy consumption [W]
125
Loudness [dB]
48
Type of operation
Extraction or absorption
Color
INOX stainless steel
The appliance meets the requirements of the applicable
norms.
The appliance is in conformity with the requirements of the
directives:
Low voltage appliance (LVD) – 2006/95/EC.
–
Electromagnetic compatibility (EMC) – 2004/108/EC.
–
The appliance was marked by a CE sign on the rating label.