Chapter 2 Hardware Installation and Connections
IES-5000 Series User’s Guide
32
Figure 9
Tightening Card Thumbscrews
2.3.2 Removing MSC and Line Cards
1
Disconnect all cables from the card.
2
Loosen the two thumbscrews.
3
Pull the two ejector levers firmly until the front of the card is clear of the chassis. Pull the
ejector levers until they are perpendicular to the front panel.
4
Grasp the center of the front panel of the card with one hand and place the other hand
under the card to support it.
5
Slide the card out of the slot.
Figure 10
Loosening Card Thumbscrews
