4
iNUKE NU6000DSP/NU3000DSP/NU1000DSP User Manual
1. Introduction
1.1 Before you get started
1.1.1 Shipment
Your iNUKE amplifier was carefully packed at the factory, and the packaging is
designed to protect the unit from rough handling. Nevertheless, we recommend
that you carefully examine the packaging and its contents for any signs of
physical damage that may have occurred during transit.
•
If the unit is damaged, please do NOT return it to BEHRINGER, but notify
your dealer and the shipping company immediately. Otherwise, claims for
damage or replacement may not be granted.
1.1.2 Initial operation
Please make sure the unit is provided with sufficient ventilation, and never place
your iNUKE amp on top of other heat-emanating equipment or in the vicinity of a
heater to avoid the risk of overheating.
The mains connection is made via the enclosed power cord and a standard IEC
receptacle. It meets all international safety certification requirements.
•
Please make sure that all units have a proper ground connection. For your
own safety, never remove or disable the ground conductor from the unit or
the AC power cord.
•
The sound quality may diminish within the range of powerful broadcasting
stations and high-frequency sources. Increase the distance between the
transmitter and the device and use shielded cables for all connections.
1.1.3 Online registration
Please register your new BEHRINGER equipment right after your purchase
by visiting http://behringer.com and read the terms and conditions of our
warranty carefully.
Should your BEHRINGER product malfunction, it is our intention to have it
repaired as quickly as possible. To arrange for warranty service, please contact
the BEHRINGER retailer from whom the equipment was purchased. Should
your BEHRINGER dealer not be located in your vicinity, you may directly contact
one of our subsidiaries. Corresponding contact information is included in the
original equipment packaging (Global Contact Information/European Contact
Information). Should your country not be listed, please contact the distributor
nearest you. A list of distributors can be found in the support area of our website
(http://behringer.com).
Registering your purchase and equipment with us helps us process your repair
claims more quickly and efficiently.
2. Control Elements
2.1 Front panel
(1)
USB
connection enables firmware updates and control over parameters via
computer. Please visit Behringer.com to download DSP control software for
your computer. The USB port is for amplifier configuration only.
(2)
SIGNAL and LIMIT LEDs
display the signal level for each channel. Reduce
the input gain if the red LIMIT LED lights up continuously.
(3)
CH A/CH B CONTROLS
adjust the input level. To increase signal gain,
rotate the knobs clockwise; to reduce the gain, rotate the knobs
counter-clockwise.
(4)
PROCESS
button steps through the DSP processing modules.
(5)
SETUP
button steps through parameters within DSP processing modules.
(6)
LCD SCREEN
displays the current DSP module and parameter settings.
(7)
UP/DOWN/EXIT
buttons step through DSP modules and parameters or exit
to the top-level iNUKE screen (center button).
(8)
SELECT
encoder knob toggles between Graphic and Edit modes
(when pressed) and changes parameter values (when rotated).
(9)
POWER
button turns the amplifier on and off.
(1)
(3)
(4)
(7)
(2)
(5)
(6)
(8)
(9)
Front panel control elements
