P a r t   9 :   G a s   c o n v e r t i o n

Your  cooker  can  operate  both  Natural  Gas 
and LPG. You can convert by changing the 

gas  source  and  the  top  burner,  oven  and 
grill  injectors.  The  replacement  procedure 
of  the  injectors  are  explained  below. 

Call authorized Service for gas 
convertion.

Replacement of the top burner injector

Take off the burner head and burner cap before 
starting this procedure. Then:

1.  Remove the injector inside the top burner 

with a suitable bit. Later, install the new injector 

by covering the injector threads 

with leakage

preventing 

name failure

material. 

device

spark plug

Reduced Tap Fiow
in modeis with Removal of the
control panel

Removal of the control panel

1.

 Open the front door.

2.

 Unscrew the two screws of the control 

panel and take the control panel bottom 
sheet.

3.

 Release the control panel from the 

two notches at the top, slightly pull it 
to the bottom front and keep it free 
with its cables connected.

Ignite the burner that should be adjusted, 

turn  the  knob  to  the  reduced  position, 

pull and take the knob off.

4.

 With a screwdriver, make the tap 

reduced flow adjustment from the 
injector that is on the gas tap (only the 
head is visible with the bolt shape).

It is sufficient to tight to screw 
completely, in butane/propane gas.
For the natural gas, you should turn the 
screw counter-clockwise 
once. The normal length of a straight 

flame in the reduced position

31

should be 6 - 7mm.
If the flame is higher than the desired 
position, turn the screw clockwise. If its 
smaller to the opposite.
For the last control of the burning of 
the cooker, bring the cooker high-flame 
and reduced positions and check 
whether the flame is on or off.