1
2
3
4
5
6
HOW TO MAKE COPIES
- 28 -
●
HOW TO MAKE COPIES
Before Making Copies
Storage of color copies
When storing color copies, be careful of the following:
• Avoid a place exposed to light. The colors may fade when
they are stored in such a place for a long time.
• If copies are stored pressed between plastic sheets made
of chloroethylene for a long time, toner may melt and stick
to the plastic. For long-time storage, use polyethylene
binders.
• When a color copy is folded, toner at the folded part may
flake off. Do not fold color copies when storing them.
• Toner on copies may melt if it touches solvent or ink not
fully dried. Keep copies away from them.
• When copies are left under an extremely high temperature
environment such as in the vicinity of a heater, toner may
melt. Store them at room temperature and avoid extreme
temperature changes.
Forgery prevention function
This equipment has a forgery prevention function. Therefore,
scan or copy function might not operate correctly.
Placing Originals
Acceptable originals
When the RADF (Reversing Automatic Document Feeder) is
used, 2-sided originals can be automatically scanned one
sheet after another. When the original glass is used, originals
such as OHP films, tracing paper, booklet or 3-dimensional
objects, that cannot be placed on the RADF can be scanned,
as well as plain paper.
Note
• Automatic size detection does not work properly when A/B
format originals are used in equipment for North America. It
does not work properly when LT format originals are used in
equipment other than that for North America.
• In some models, automatic size detection does not work
properly when K format paper is used for printing. (K format
is a standard paper size in China.)
• Do not place any heavy objects (8 Kg(18lb.) or over) on the
original glass and do not press on it with force.
• Be sure to place ST-size or A5-size originals in a landscape
direction when using the RADF.
• A maximum of 1000 sheets can be scanned per 1 copy job
or up until the embedded memory becomes full.
Placing originals on the original glass
The original glass can be used for originals such as OHP films
or tracing paper, as well as plain paper, that cannot be placed
on the RADF.
Do not place any heavy objects (8 Kg(18lb.) or over) on the
original glass and do not press on it with force.
Breaking the glass could injure you.
1
Raise the Original Cover or the RADF.
Note
• Raise it 60 degrees or more so that the size of the
original can be detected correctly.
2
Place the original with its face down on the
original glass and align it with the left rear
corner of the glass.
Location
Original glass
RADF
Maximum size
Length:215.9mm(8.5")
Width:355.6mm(14")
Paper weight
20mm or less
1-sided originals: 35
- 157 g/m
2
(9.3 -
41.8 lb.)
2-sided originals: 50
- 157 g/m
2
(13.3 -
41.8 lb.)
Acceptable
sizes for
automatic
size detection
Other than North
America: A4, B5, 8K,
16K
North America: LG,
LT
Other than North
America: A4, B5,
FOLIO
North America: LG,
LT
