52

53

Step 1

Click "Control Panel" on the start menu. 
     

Configure the network settings

The recorder can be operated using a mouse connected to the front of the unit or from a web browser on a PC 
(excluding operations in the setup menu and certain other functions). On the following pages, operation from a 
web browser, setting up the PC and related matters will be described. 

When operating the recorder using a web browser, it is necessary in advance to configure the network settings 
of the recorder and a PC. 
When the network settings of the PC are as follows, it is unnecessary to configure the settings. It is possible to 
configure the settings and operate the recorder using a web browser after completing the connection. 
IP address: 192.168.0.2 - 192.168.0.249, 192.168.0.251 - 192.168.0.254
Subnet mask: 255.255.255.0
Default gateway: 192.168.0.1
When the settings are configured differently from the above, configure the network settings of the recorder or a 
PC. 

Configure the network settings of the recorder

The network settings of the recorder can be configured on the "Network" page - the [Basic] tab of the setup 
menu.
Refer to the chapter relating to the [Basic] tab of "Network" of the setup menu for how to operate (☞ Installation 
Guide). 

Configure the network settings of the PC

The TCP/IP setting of the PC shall be changed to conform to the settings of the recorder. When using the 
recorder with the default (IP address:192.168.0.250), set the IP address of the PC to "192.168.1.xxx (a number 
from 2 to 254 except 250 (this recorder))".
The settings described in these operating instructions are based on the standard settings for Windows 7. Refer 
to the operating instructions of the respective OS for further information. 
     

 →  "Control panel" will be displayed. 

Important:

 •  Log in to the PC as an administrator.