20
Using the projector and remote control
Eng
lish
Adjust the image
Adjusting the angle height
There are two adjuster feet on the bottom of the projector. These can be
used if necessary to change the projection angle. Screw the feet in or out
as appropriate to aim and level the projection angle.
If the screen and the projector are not perpendicular to each other,
the projected image becomes vertical trapezoidal. To correct this
problem, adjust the value of Keystone in the Setup menu.
Auto-adjusting the image
With one press of the Auto button on the projector, the built-in intelligent auto-
adjustment function will re-adjust the values of Frequency and Clock to provide
the best image quality.
The current source information will be displayed at the bottom right corner of the
screen for 3 seconds.
The screen will be blank while the auto-adjustment is functioning.
Fine-tuning the image size and clarity
Optimizing the image
To optimize the image, use the remote control or on-screen menus. For the operation of on-screen menus, please
refer to page
.
The following steps are optional. You do not need to follow every step. It depends on the image quality you
desire.
1. Adjust the projected image to the size that you
need using the zoom ring.
2. Then sharpen the image by rotating the focus
ring.
