6 

Safety, regulatory and legal information  

Eng
lish

Safety instructions (continued)

3.

When you think service or repair is 
required, take the projector only to a 
suitably qualified technician. 

4.

To reduce the risk of electric shock, do not 
disassemble this appliance. There are no 
user serviceable parts inside. Take it to a 
qualified technician when service or repair 
is required. Incorrect reassembly can 
cause a malfunction of the projector or 
electric shock when the appliance is 
subsequently used. 

5.

Do not look straight at the projector lens 
during operation. The intense light beam 
may damage your eyes. 

6.

Never replace the lamp assembly or any 
electronic components unless the 
projector is unplugged. 

7.

In some countries, the line voltage is NOT 
stable. This projector is designed to 
operate safely with a mains voltage 
between 100 and 240 volts AC, but could 
fail if power cuts or surges of ±10 volts 
occur. In areas where the mains voltage 
may fluctuate or cut out, it is 
recommended that you connect your 
projector through a power stabilizer, surge 
protector or uninterruptible power supply 
(UPS).

8.

The lamp becomes extremely hot during 
operation. Allow the projector to cool for 
approximately 45 minutes prior to 
removing the lamp assembly for 
replacement. 

9.

Do not operate lamps beyond the rated 
lamp life. Excessive operation of lamps 
beyond the rated life could cause them to 
break on rare occasions.