![background image](/i/dell/157685/dell-5330dn/h/dell-5330dn-118.png)
The rear door of output expander is not
securely latched.
Close the door until it locks into place.
The fuser door is not securely latched.
door until it locks into place.
Close the tray until it locks into place.
HCF(High Capcity Feeder) is open.
Close the HCF until it locks into place.
There is no paper in the tray.
Load paper in the tray. See
"Loading
Print Media in the Paper Tray"
.
Load paper in the HCF. See
"Using the
High Capacity Feeder"
.
There is no paper in the multi-purpose
feeder.
Load paper in the multi-purpose feeder.
See
"Using the Multi-purpose Feeder"
The paper size specified in the printer
properties does not match the paper
being loading.
Load the correct paper in the tray.
Paper has jammed around the toner
cartridge area.
Paper has jammed in the feeding area of
the multi-purpose feeder.
Paper has jammed in the feeding area of
the paper tray.
"Paper Feed Jam (optional trays)"
Paper has jammed in the paper exit area
or around the toner cartridge area.
Paper has jammed in the paper exit area. Clear the jam. See
Paper has jammed during duplex
printing.
Paper has jammed during duplex
printing.
The output tray of output expander is
full.
There is a problem in the fuser unit.
Unplug the power cord and plug it back
in.
There is a problem in the fuser unit.
Unplug the power cord and plug it back
in.
There is a problem in the fuser unit.
Unplug the power cord and plug it back
in.
A problem has occurred in the LSU(Laser
Scanning Unit).
Unplug the power cord and plug it back
in.
A problem has occurred in the LSU(Laser
Scanning Unit).
Unplug the power cord and plug it back
in.
There is a problem in the cooling fan of
the printer.
There is a problem in the SMPS fan of the
printer.
Unplug the power cord and plug it back
in.
The fuser unit is not installed or not
detected.
Install the fuser unit or open and then
close the
There is a problem in your printer system. Unplug the power cord and plug it back
There is a problem in the development
motor of the printer.
Unplug the power cord and plug it back
in.
The printer is in power save mode.
When data is received, it switches to on-
line automatically.