![background image](/i/dell/158596/dell-b1260dn/h/dell-b1260dn-031.png)
Media and tray
-
Curl:
Must lie flat with no more than 13 mm of curl in any direction.
Preprinted paper
-
Condition:
Do not use labels with wrinkles, bubbles, or other
indications of separation.
When loading preprinted paper, the printed side should be facing up with an
uncurled edge at the front. If you experience problems with paper feeding, turn
• Make sure that there is no exposed adhesive material between labels.
the paper around. Note that print quality is not guaranteed.
Exposed areas can cause labels to peel off during printing, which can cause
paper jams. Exposed adhesive can also cause damage to machine
components.
• Do not run a sheet of labels through the machine more than once. The
adhesive backing is designed for only a single pass through the machine.
• Do not use labels that are separating from the backing sheet or are wrinkled,
bubbled, or otherwise damaged.
Card stock/ Custom-sized paper
• Must be printed with heat-resistant ink that will not melt, vaporize, or
release hazardous emissions when subjected to the machine’s fusing
temperature for 0.1 second (about 170°C (338°F)).
• Preprinted paper ink must be non-flammable and should not adversely
affect machine rollers.
• Before you load preprinted paper, verify that the ink on the paper is dry.
During the fusing process, wet ink can come off preprinted paper, reducing
print quality.
• In the software application, set margins at least 6.4 mm (0.25 inches) away
from the edges of the material.
2. Learning the Basic Usage
31