1 

WPS-PBC (Wi-Fi | WPS Button) 

You can start WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) by pressing the 

 (Wi-Fi | WPS) 

button. 

NOTE: 

WPS-PBC is available only when the wireless LAN access point (Registrar) or router supports WPS-PBC. 

NOTE: 

Before starting WPS-PBC with the 

(Wi-Fi | WPS) button, confirm the position of the WPS button (button name may 

vary) on the wireless LAN access point (Registrar) or router. For information about WPS operation on the wireless LAN access 

point (Registrar) or router, refer to the manual supplied with the product. 

NOTE: 

For more information on the 

(Wi-Fi | WPS) button, see "Status of Wi-Fi | WPS Button Backlight" on page 78. 

If a problem occurs or error messages are displayed on the operator panel, see "Wireless Problems" on page 224. 

Press and hold the 

(Wi-Fi | WPS) button on the printer for 2 seconds.

Ensure that the

(Wi-Fi | WPS) button starts to flash and 

Press WPS Button on Router

appears on 

the operator panel. 

2 

Start the WPS operation on the wireless LAN access point (Registrar) or router within two minutes. 

3 

When the WPS operation is successful and the printer is rebooted, wireless LAN connection setting is completed. 

WPS-PBC (Operator Panel Menu) 

You can start WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) from the operator panel. 

NOTE: 

WPS-PBC is available only when the wireless LAN access point (Registrar) or router supports WPS-PBC. 

NOTE: 

Before starting WPS-PBC, confirm the position of the WPS button (button name may vary) on the wireless LAN access 

point (Registrar) or router. For information about WPS operation on the wireless LAN access point (Registrar) or router, refer to 

the manual supplied with the product. 

NOTE: 

A Password is required to enter 

Admin Menu

when 

Panel Lock Set 

is set to 

Enable

. In this case, enter 

the password you specified, and press 

the 

(Set) button. 

1 

Press the 

(Menu)

 button.

2 

Press the 

button until 

Admin Menu

 appears, and then press the 

(Set)

 button.

3 

Press the 

button until 

Network

appears, and then press the 

(Set)

 button.

4 

Press the 

button until 

WPS Setup

appears, and then press the 

(Set)

 button.

5 

Ensure that 

Push Btn. Ctrl

 appears, and then press the

(Set)

 button.

6 

Ensure that 

Are you sure?

 appears, and then press the

(Set)

 button.

Ensure that 

Press WPS Button on Router

 is displayed, and start the WPS-PBC on the wireless LAN 

access point (Registrar) or router within two minutes. 

7 

When the WPS operation is successful and the printer is rebooted, wireless LAN connection setting is completed. 

Connecting Your Printer 

31