![background image](/i/kawasaki/160295/kawasaki-vn1600-classic-2003/h/kawasaki-vn1600-classic-2003-049.png)
PERIODIC MAINTENANCE 2-27
Periodic Maintenance Procedures
Brakes
Brake Pad Wear Inspection
•
Check the lining thickness [A] of the pads in each caliper.
If the lining thickness of either pad is less than the service
limit [B], replace both pads in the caliper as a set (see
Brakes chapter).
Pad Lining Thickness
Standard:
Front:
4.5 mm (0.18 in.)
Rear:
7.5 mm (0.295 in.)
Service Limit:
1 mm (0.04 in.)
Brake Hose and Connection Inspection
•
Inspect the brake hose and fittings for deterioration,
cracks and signs of leakage.
○
The high pressure inside the brake line can cause fluid to
leak [A] or the hose to burst if the line is not properly main-
tained. Bend and twist the rubber hose while examining
it.
Replace the hose if any cracks [B] or bulges [C] are no-
ticed.
Tighten any loose fittings.
Brake Fluid Level Inspection
•
Check that the brake fluid level in the front brake reservoir
[A] is above the lower [B] level line.
NOTE
○
Hold the reservoir horizontal by turning the handlebar
when checking brake fluid level.
If the fluid level is lower than the lower level line, fill the
reservoir to the upper level line [A] in the reservoir [B].