![background image](/i/kawasaki/160295/kawasaki-vn1600-classic-2003/h/kawasaki-vn1600-classic-2003-325.png)
WHEELS/TIRES 10-11
Wheels (Rims)
Wheel Coupling Installation
•
Replace the O-ring [A] and the retaining ring [B].
•
Grease the following:
O-ring
Bosses [C] of Rear Drum Hub
•
Install:
Rubber Damper [D]
Coupling [E]
Retaining Ring
Wheel Inspection
•
Raise the front or rear wheel off the ground.
Special Tools - Jack: 57001-1238
Attachment Jack: 57001-1398
•
Spin [A] the wheel lightly, and check for roughness or
binding.
If roughness or binding is found, replace the hub bearings.
•
Inspect the front and rear axles for damage (see this
chapter).
If the axle is damaged or bent, replace it.
•
Inspect the wheel for small cracks, dents, bending, or
warp.
If there is any damage to the wheel, replace the wheel.
•
Remove the wheel, and support it without the tire by the
axle.
•
Measure the rim runout, radiator [A] and axial [B], with a
dial gauge.
If the rim runout exceeds the service limit, check the hub
bearings. Replace them if they are damaged.
If the problem is not due to the bearings, replace the
wheel.
Rim Runout
Service Limit:
Axial
0.5 mm (0.02 in.)
Radial
0.8 mm (0.03 in.)
WARNING
Never attempt to repair a damaged wheel. If there
is any damage besides wheel bearings, the wheel
must be replaced to insure safe operational condi-
tion.