Operation and settings
51
4
Oper
ation and se
ttings
Compass
You can display the north, south, east and west information
on the screen.
1. Select [COMPASS] option on the [SPECIAL] menu.
2. Set the [COMPASS] option to [SET] and then press
button.
3. Select north point using the PTZ control buttons and
then press button.
4. Set the [COMPASS] option to [ON].
Home position
The home position is the camera’s basic position.
The camera returns to this position whenever you want.
Use the following procedure to make the home position.
1. Select [HOME POSITION] option on the [SPECIAL]
menu.
2. Use or button to set it ON.
3. Press button.
4. Select [SET] option and then press button.
5. Select the home position where you want and then
press button.
6. Select [DWELL TIME] option and then select the dwell
time.
7. Select [RETURN] option and press button to exit the
setting menu.
»
Go to Home position
1. Select [HOME POSITION] option on the [SPECIAL]
menu.
2. Use or button to set it ON.
3. Press button.
4. Select [GO] option and then press button. The
camera will move to the home position.
NOTE
• If you do not want to use the home position
function, set the [HOME POSITION] option to [OFF].
• If you set the [HOME POSITION] to [ON], the [AUTO
RETURN] option is set to [OFF] automatically and you
can not use it.
Auto return
This function can be used to specify automatic return to a
particular mode if a certain amount of time elapses without
any operation being performed.
1. Select [AUTO RETURN] option on the [SPECIAL] menu.
2. Use or button to set it [ON] and then press
button.
3. Select [RETURN TIME] option and then select the auto
return time.
4. Select [RETURN] option and press button to exit the
setting menu.
NOTE
If you set [AUTO RETURN] to [ON], the [HOME POSITION]
option is set to [OFF] automatically and you can not use
it.
Tilt limit
You can specify the tilt range. If you set this function, the
camera is able to tilt from 15º to 165º.
1. Select [TILT LIMIT] option on the [SPECIAL] menu.
2. Use or button to set it [ON]. If you do not want to
use this function, set it to [OFF].
