![background image](/i/zelmer/158781/zelmer-zzs-9012xe/h/zelmer-zzs-9012xe-123.png)
123
ZS-003_v03
SIZE AND INSTALLATION OF THE UNIT
1
The wooden unit should be constructed according to Figure
3
below.
3
The unit should be constructed according to the given measurements.
The overall weight of the unit should not exceed 4.5 kg.
2
Attach the hook to the wooden unit and guide it into the hole in the outside door of
the dishwasher (see Figure
4a
). After positioning the unit, install it on the outside door by
means of bolts and screws (see Figure
4b
).
upper hook
lower hook
cone-head
bolts
4x18 bolts
plate
fastening for the
unit
unit door
the outside door
of the dishwasher
distancing pad
4a
Installation of the unit.
4b
1. Remove the plate.
2. Screw the bolt in.
3. Put the pad back on.
Installation of the wooden unit.
REGULATION OF DOOR SPRING TENSION
Door springs have default tension for outside door. If the wooden unit is installed, it is
necessary to adjust the tension of the outside door anew. Turn the regulating bolt to
tighten/loosen the steel cable (see Figure
5
).
Door spring tension is right, when the door are in a horizontal position when fully open, and
lift for closing by a slight move of a finger.
Regulation of door spring tension.
5
loosen
depth 10
depth 10
depth 10