Инструкция для ZYXEL GS1920-48

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 13 Spanning Tree Protocol

GS1920 Series User’s Guide

117

The following table describes the labels in this screen.

Table 45

Advanced Application > Spanning Tree Protocol > RSTP

LABEL

DESCRIPTION

Status

Click Status to display the RSTP Status screen

(see Figure 91 on page 118)

Active

Select this check box to activate RSTP. Clear this checkbox to disable RSTP.

Note: You must also activate

Rapid Spanning Tree

in the

Advanced Application >

Spanning Tree Protocol > Configuration

screen to enable RSTP on the Switch.

Bridge Priority

Bridge priority is used in determining the root switch, root port and designated port. The
switch with the highest priority (lowest numeric value) becomes the STP root switch. If all
switches have the same priority, the switch with the lowest MAC address will then become
the root switch. Select a value from the drop-down list box.

The lower the numeric value you assign, the higher the priority for this bridge.

Bridge Priority determines the root bridge, which in turn determines Hello Time, Max Age
and Forwarding Delay.

Hello Time

This is the time interval in seconds between BPDU (Bridge Protocol Data Units)
configuration message generations by the root switch. The allowed range is 1 to 10
seconds.

Max Age

This is the maximum time (in seconds) the Switch can wait without receiving a BPDU
before attempting to reconfigure. All Switch ports (except for designated ports) should
receive BPDUs at regular intervals. Any port that ages out STP information (provided in
the last BPDU) becomes the designated port for the attached LAN. If it is a root port, a
new root port is selected from among the Switch ports attached to the network. The
allowed range is 6 to 40 seconds.

Forwarding Delay This is the maximum time (in seconds) the Switch will wait before changing states. This

delay is required because every switch must receive information about topology changes
before it starts to forward frames. In addition, each port needs time to listen for
conflicting information that would make it return to a blocking state; otherwise,
temporary data loops might result. The allowed range is 4 to 30 seconds.

As a general rule:

Note: 2 * (Forward Delay - 1) >= Max Age >= 2 * (Hello Time + 1)

Port

This field displays the port number.

Settings in this row apply to all ports.

Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.

Note: Changes in this row are copied to all the ports as soon as you make them.

Active

Select this check box to activate RSTP on this port.

Edge

Select this check box to configure a port as an edge port when it is directly attached to a
computer. An edge port changes its initial STP port state from blocking state to forwarding
state immediately without going through listening and learning states right after the port
is configured as an edge port or when its link status changes.

Note: An edge port becomes a non-edge port as soon as it receives a Bridge Protocol Data

Unit (BPDU).

Priority

Configure the priority for each port here.

Priority decides which port should be disabled when more than one port forms a loop in a
switch. Ports with a higher priority numeric value are disabled first. The allowed range is
between 0 and 255 and the default value is 128.