![background image](/i/zyxel/152077/zyxel-gs1920-48/h/zyxel-gs1920-48-302.png)
Chapter 37 Maintenance
GS1920 Series User’s Guide
302
Figure 222
Management > Maintenance > Firmware Upgrade
The following table describes the labels in this screen.
37.4
Restore
a
Configuration
File
Use this screen to restore a previously saved configuration from your computer to the Switch using
the Restore Configuration screen.
Table 149
Management > Maintenance
LABEL
DESCRIPTION
Name
This is the name of the Switch that you’re configuring.
Version
The Switch has two firmware sets, Firmware 1 and Firmware 2, residing in flash.
•
Running shows the version number (and model code) and MM/DD/YYYY creation date
of the firmware currently in use on the Switch (Firmware 1 or Firmware 2). The
firmware information is also displayed at System Information in Basic Settings.
•
Firmware 1 shows its version number (and model code) and MM/DD/YYYY creation
date.
•
Firmware 2 shows its version number (and model code) and MM/DD/YYYY creation
date.
Current Boot
Image
This displays which firmware is currently in use on the Switch (Firmware 1 or Firmware
2).
Config Boot
Image
Select which firmware (Firmware 1 or Firmware 2) should load, click Apply and reboot
the switch to see changes, you will also see changes in the Current boot image field above
as well.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Firmware
Choose to upload the new firmware to (Firmware) 1 or (Firmware) 2.
File Path
Type the path and file name of the firmware file you wish to upload to the Switch in the
File Path text box or click Browse to locate it.
Upgrade
Click Upgrade to load the new firmware. Firmware upgrades are only applied after a
reboot. To reboot, go to Management > Maintenance > Reboot System and click
Config 1 or Config 2 (Config 1 is Firmware 1 and Config 2 is Firmware 2).