Инструкция для ZYXEL GS1920-48

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 9 VLAN

GS1920 Series User’s Guide

9.6

Subnet Based VLAN

Subnet based VLANs allow you to group traffic into logical VLANs based on the source IP subnet you
specify. When a frame is received on a port, the Switch checks if a tag is added already and the IP
subnet it came from. The untagged packets from the same IP subnet are then placed in the same
subnet based VLAN. One advantage of using subnet based VLANs is that priority can be assigned to
traffic from the same IP subnet.

For example, an ISP (Internet Services Provider) may divide different types of services it provides
to customers into different IP subnets. Traffic for voice services is designated for IP subnet
172.16.1.0/24, video for 192.168.1.0/24 and data for 10.1.1.0/24. The Switch can then be
configured to group incoming traffic based on the source IP subnet of incoming frames.

You configure a subnet based VLAN with priority 6 and VID of 100 for traffic received from IP subnet
172.16.1.0/24 (voice services). You also have a subnet based VLAN with priority 5 and VID of 200
for traffic received from IP subnet 192.168.1.0/24 (video services). Lastly, you configure VLAN with
priority 3 and VID of 300 for traffic received from IP subnet 10.1.1.0/24 (data services). All

Settings in this row apply to all ports.

Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.

Note: Changes in this row are copied to all the ports as soon as you make them.

Ingress Check

If this check box is selected, the Switch discards incoming frames on a port for VLANs that
do not include this port in its member set.

Clear this check box to disable ingress filtering.

PVID

A PVID (Port VLAN ID) is a tag that adds to incoming untagged frames received on a port
so that the frames are forwarded to the VLAN group that the tag defines.

Enter a number between 1and 4094 as the port VLAN ID.

GVRP

Select this check box to allow GVRP on this port.

Acceptable Frame
Type

Specify the type of frames allowed on a port. Choices are All, Tag Only and Untag Only.

Select All from the drop-down list box to accept all untagged or tagged frames on this
port. This is the default setting.

Select Tag Only to accept only tagged frames on this port. All untagged frames will be
dropped.

Select Untag Only to accept only untagged frames on this port. All tagged frames will be
dropped.

VLAN Trunking

Enable VLAN Trunking on ports connected to other switches or routers (but not ports
directly connected to end users) to allow frames belonging to unknown VLAN groups to
pass through the Switch.

Isolation

Select this to allows this port to communicate only with the CPU management port and
the ports on which the isolation feature is not enabled.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Table 33

Advanced Application > VLAN > VLAN Configuration > VLAN Port Set

LABEL

DESCRIPTION