![background image](/i/zyxel/152077/zyxel-gs1920-48/h/zyxel-gs1920-48-028.png)
Chapter 3 Hardware Panels
GS1920 Series User’s Guide
28
1
Insert the transceiver into the slot with the exposed section of PCB board facing down.
2
Press the transceiver firmly until it clicks into place.
3
The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is
functioning properly.
4
Close the transceiver’s latch (latch styles vary).
5
Connect the fiber optic cables to the transceiver.
Figure 11
Transceiver Installation Example
Figure 12
Connecting the Fiber Optic Cables
3.1.2.2 Transceiver Removal
Use the following steps to remove a mini-GBIC transceiver (SFP module).
1
Remove the fiber optic cables from the transceiver.
2
Open the transceiver’s latch (latch styles vary).
3
Pull the transceiver out of the slot.
Figure 13
Removing the Fiber Optic Cables
Figure 14
Opening the Transceiver’s Latch Example