1
Installing the driver locally
A locally connected machine is a machine directly attached to your computer
Insert the supplied software CD into your CD-ROM drive.
2
using the cable. If your machine is attached to a network, skip the following
The software CD should automatically run and an installation window
steps below and go on to installing a network connected machine’s driver (see
will appear.
"Installing driver over the network" on page 81).
If the installation window does not appear, click
Start
>
All programs
>
Accessories
>
Run
.
• If you are a Macintosh, Linux, or Unix OS user, refer to the "Software
X:\
Setup.exe
replacing “X” with the letter, which represents your CD-
ROM drive and click
OK
.
• The installation window in this
User’s Guide
may differ depending on the
machine and interface in use.
Select
Next
.
3
• Selecting
Custom Installation
allows you to choose which programs to
install.
• Only use a USB cable no longer than 3 meters (118 inches).
Windows
Make sure that the machine is connected to your computer and
powered on.
If the “
Found New Hardware Wizard
” appears during the installation
procedure, click
Cancel
to close the window.
1. Introduction