![background image](/i/gorenje/149822/gorenje-gi512w/h/gorenje-gi512w-018.png)
17
PRIMARY AIR ADJUSTMENT
To access the primary air adjusting screw (5), open or remove oven door and remove
oven bottom (2). By unscrewing the adjusting screw the quantity of primary air is
increase, by tightening it is reduced. The air/gas mixture is correct when the flame
has blue color.
Adjust screw 5 for value X in accordance with the table, and tighten the nut.
Check that the burner is working properly: the flame must be blue and sharp, without
a yellow tip.
РЕГУЛИРОВКА КОЛИЧЕСТВА ПОДСАСЫВАЕМОГО
ПЕРВИЧНОГО ВОЗДУХА
Отрегулировать количество подсасываемого воздуха можно с помощью
регулировочного винта. Но прежде нужно открыть дверцу духовки (при
необходимости, дверцу снять с петель) и вытащить дно.
При
отвинчивании
регулировочного
винта
количество
первичного
подсасываемого воздуха увеличивается, при завинчивании - уменьшается.
Положение винта (величину „Х“) нужно установить в соответствии с
нижеприведённой таблицей.
ADJUSTMENT OF OVEN BURNER MINIMUM POWER
On completion of this operation, proceed as follows:
Remove the oven bottom.
Oven temperature selector
Disconnect the cooker from the mains power supply. Lifř the oven temperature
selector knob. For propane/butane fully tighten screw G.
For natural gas unscrew screw G by a ½ or ¾ turn for natural gas
Light the oven burner and close the oven door.
Oven temperature selector
Set the temperature selector control knob to position 8 and heat the oven for 15
minutes.
Then set the temperature selector knob to position 1 and use screw G to adjust the
flame.
Right turn reduces the height of the flame, and left turn increases the height. The
adjustment is correct when the body of the flame is about 3 to 4 mm high.
Replace the knob and set it to the switch off position, then replace the oven base.
If the flame sensor does not operate properly, check its position according to fig.
РЕГУЛИРОВКА МОЩНОСТИ В ПОЛОЖЕНИИ „МАЛОЕ ПЛАМЯ“
Данная операция выполняется следующим способом:
Нужно открыть дверцу духовки и вытащить дно.
Установите ручку крана на “МАКСИМАЛЬНУЮ МОЩНОСТЬ”.
З ажгите газ горелки, закройте дверцу и прогрейте духовку в течение,
приблизительно, 15 минут.
Затем установите ручку крана в положение “МАЛОЕ ПЛАМЯ” и винтом G
выполните окончательную регулировку.
При повороте винта вправо пламя уменьшается, а при повороте влево -
увеличивается. Мощность горелки считается правильно отрегулированной, если
внутренний конус пламени достигает высоты от 3 до 4 мм, а температура в
центре духовки должна быть максимально 160°C.