![background image](/i/infiniti/155628/infiniti-fx35-2009/h/infiniti-fx35-2009-137.png)
Black plate (135,1)
Model "S51-D" EDITED: 2008/ 3/ 26
the programmed HomeLink
®
button -
releasing when the device begins to
activate.
5. If the indicator light on HomeLink
®
blinks rapidly for two seconds and then
turns solid, HomeLink
®
has picked up a
“
rolling code
”
garage door opener
signal. You will need to proceed with
the next steps to train HomeLink
®
,
completing the programming may re-
quire a ladder and another person for
convenience.
6. Push and release the program button
located on the garage door opener
’
s
motor to activate the
“
training mode
”
.
This button is usually located near the
antenna wire that hangs down from the
motor. If the wire originates from under
a light lens, you will need to remove the
lens to access the training button.
NOTE:
Once you have pushed and released
the training button on the garage door
opener
’
s motor and the
“
training light
”
is lit, you have 30 seconds in which to
perform step 7. For convenience, use
the help of a second person to assist
when performing this step.
7. Quickly (within 30 seconds of pushing
and releasing the garage door opener
training button) and firmly push and
release the HomeLink
®
button you
’
ve
just programmed. Push and release the
HomeLink
®
button up to three times to
complete the training.
8. Your HomeLink
®
button should now be
programmed. To program the remaining
HomeLink
®
buttons for additional door
or gate openers, follow steps 2 through
8 only.
NOTE:
Do not repeat step 1 unless you want to
“
clear
”
all previously programmed
HomeLink
®
buttons.
If you have any questions or are having
difficulty programming your HomeLink
®
buttons, please refer to the HomeLink
®
web site at: www.homelink.com or call 1-
800-355-3515.
PROGRAMMING HomeLink
®
FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting
after 2 seconds. To program your hand-
held transmitter to HomeLink
®
, continue to
push and hold the HomeLink
®
button (note
steps 2 through 4 under
“
Programming
HomeLink
®
”
) while you push and re-push
(
“
cycle
”
) your hand-held transmitter every
2 seconds until the indicator light flashes
rapidly (indicating successful program-
ming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the
“
cycling
”
process to prevent possible
damage to the garage door opener com-
ponents.
OPERATING THE HomeLink
®
UNI-
VERSAL TRANSCEIVER
HomeLink
®
Universal Transceiver (once
programmed) may now be used to activate
the garage door, etc. To operate, simply
push
the
appropriate programmed
HomeLink
®
Universal Transceiver button.
The red indicator light will illuminate while
the signal is being transmitted.
PROGRAMMING TROUBLE-DIAGNO-
SIS
If HomeLink
®
does not quickly learn the
hand-held transmitter information:
.
replace the hand-held transmitter bat-
teries with new batteries.
.
position the hand-held transmitter with
its battery area facing away from the
HomeLink
®
surface.
Instruments and controls
2-67