Инструкция для INFINITI FX35 (2009)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Black plate (318,1)

Model "S51-D" EDITED: 2008/ 3/ 26

When canceling the manual shift mode,
return the selector lever to the D (Drive)
position. The transmission returns to the
normal driving mode.

When you pull the paddle shifter while in
the D (Drive) position, the transmission will
shift to the upper or lower range tempora-
rily. The transmission will automatically
return to the D (Drive) position after a short
period of time. If you want to return to the
D (Drive) position manually, pull and hold
the paddle shifter for about 1.5 seconds.

In the manual shift mode, the shift range is
displayed on the position indicator in the
meter.

Shift ranges up or down one by one as
follows:

7 (7th):

Use this position for all normal forward
driving at highway speeds.

6 (6th) and

5 (5th):

Use this position when driving up long
slopes, or for engine braking when driving
down long slopes.

4 (4th),

3 (3rd) and

2 (2nd):

Use for hill climbing or engine braking on
downhill grades.

1 (1st):

Use this position when climbing steep hills
slowly or driving slowly through deep
snow, or for maximum engine braking on
steep downhill grades.

Remember not to drive at high speeds
for extended periods of time in lower
than 7th gear. This reduces fuel econ-
omy.

Moving the selector lever rapidly to the
same side twice will shift the ranges in
succession.

In the manual shift mode, the trans-
mission may not shift to the selected
gear. This helps maintain driving per-
formance and reduces the chance of
vehicle damage or loss of control.

In the manual shift mode, the trans-
mission automatically shifts down to
1st gear before the vehicle comes to a
stop. When accelerating again, it is
necessary to shift up to the desired
range.

Accelerator downshift

—

In D (Drive) position

—

For passing or hill climbing, fully depress
the accelerator pedal to the floor. This
shifts the transmission down into the lower
gear, depending on the vehicle speed.

Fail-safe

When the fail-safe operation occurs, note
that the transmission will be locked in any
of the forward gears according to the
condition.

If the vehicle is driven under extreme
conditions, such as excessive wheel spin-
ning and subsequent hard braking, the
fail-safe system may be activated. This will
occur even if all electrical circuits are
functioning properly. In this case, push
the switch to the OFF position and wait for
3 seconds. Then push the ignition switch
back to the ON position. The vehicle
should return to its normal operating
condition. If it does not return to its
normal operating condition, have an
INFINITI dealer check the transmission
and repair if necessary.

5-16

Starting and driving