Инструкция для INFINITI FX35 (2009)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Black plate (314,1)

Model "S51-D" EDITED: 2008/ 3/ 26

Make sure the area around the vehicle
is clear.

Check fluid levels such as engine oil,
coolant, brake fluid and window
washer fluid as frequently as possible,
or at least whenever you refuel.

Check that all windows and lights are
clean.

Visually inspect tires for their appear-
ance and condition. Also check tires for
proper inflation.

Lock all doors.

Position seat and adjust head re-
straints.

Adjust inside and outside mirrors.

Fasten seat belts and ask all passen-
gers to do likewise.

Check the operation of warning lights
when the ignition switch is pushed to
the ON position. (See

“

WARNING/IN-

DICATOR LIGHTS AND AUDIBLE REMIN-
DERS

”

in the

“

2. Instruments and

controls

”

section.)

1. Apply the parking brake.

2. Move the selector lever to the P (Park)

or N (Neutral) position. (P is recom-
mended.)

The starter is designed not to operate
unless the selector lever is in either of
the above positions.

3. Push the ignition switch to the ON

position. Depress the brake pedal and
push the ignition switch to start the
engine.

To start the engine immediately, push
and release the ignition switch while
depressing the brake pedal with the
ignition switch in any position.

If the engine is very hard to start in
extremely cold weather or when
restarting, depress the accelerator
pedal a little (approximately 1/3 to
the floor) and while holding, crank
the engine. Release the accelerator
pedal when the engine starts.

If the engine is very hard to start
because it is flooded, depress the
accelerator pedal all the way to the
floor and hold it. Push the ignition
switch to the ON position to start
cranking the engine. After 5 or 6
seconds, stop cranking by pushing

the ignition switch to OFF. After
cranking the engine, release the
accelerator pedal. Crank the engine

with your foot off the accelerator
pedal

by depressing the brake

pedal and pushing the push-button
ignition switch to start the engine. If
the engine starts, but fails to run,
repeat the above procedure.

CAUTION

Do not operate the starter for more than 15
seconds at a time. If the engine does not
start, push the ignition switch to OFF and
wait 10 seconds before cranking again,
otherwise the starter could be damaged.

Warm-up

Allow the engine to idle for at least 30
seconds after starting. Do not race the
engine while warming it up. Drive at
moderate speed for a short distance
first, especially in cold weather. In cold
weather, keep the engine running for a
minimum of 2 - 3 minutes before
shutting it off. Starting and stopping
the engine over a short period of time
may make the vehicle more difficult to
start.

BEFORE STARTING THE ENGINE

STARTING THE ENGINE

5-12

Starting and driving