Инструкция для INFINITI FX35 (2009)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Black plate (382,1)

Model "S51-D" EDITED: 2008/ 3/ 26

For all-wheel drive

If you install snow tires, they must also be
the same size, brand, construction and
tread pattern on all four wheels.

SPECIAL WINTER EQUIPMENT

It is recommended that the following items
be carried in the vehicle during winter:

A scraper and stiff-bristled brush to
remove ice and snow from the windows
and wiper blades.

A sturdy, flat board to be placed under
the jack to give it firm support.

A shovel to dig the vehicle out of
snowdrifts.

Extra window washer fluid to refill the
reservoir tank.

DRIVING ON SNOW OR ICE

WARNING

Wet ice (32

F, 0

C and freezing rain),

very cold snow or ice can be slick and
very hard to drive on. The vehicle will
have much less traction or

“

grip

”

under

these conditions. Try to avoid driving on
wet ice until the road is salted or

sanded.

Whatever the condition, drive with cau-
tion. Accelerate and slow down with
care. If accelerating or downshifting too
fast, the drive wheels will lose even
more traction.

Allow more stopping distance under
these conditions. Braking should be
started sooner than on dry pavement.

Allow greater following distances on
slippery roads.

Watch for slippery spots (glare ice).
These may appear on an otherwise clear
road in shaded areas. If a patch of ice is
seen ahead, brake before reaching it. Try
not to brake while on the ice, and avoid
any sudden steering maneuvers.

Do not use the cruise control on slippery
roads.

Snow can trap dangerous exhaust gases
under your vehicle. Keep snow clear of
the exhaust pipe and from around your
vehicle.

ENGINE BLOCK HEATER (if so
equipped)

Engine block heaters are available through
INFINITI dealers to assist in cold tempera-
ture starting. The engine block heater
should be used when the outside tempera-
ture is 20

F (

−

C) or lower.

To use the engine block heater

1. Turn the engine off.

2. Open the hood and unwrap the engine

block heater cord.

3. Plug the engine block heater cord into a

grounded 3-wire, 3-pronged extension
cord.

4. Plug the extension cord into a Ground

F a u l t

I n t e r r u p t

( G F I )

p r o t e c t e d ,

grounded 110-volt AC (VAC) outlet.

5. The engine block heater must be

plugged in for at least 2 - 4 hours,
depending on outside temperatures, to
properly warm the engine coolant. Use
an appropriate timer to turn the engine
block heater on.

6. Before starting the engine, unplug and

properly store the cord to keep it away
from moving parts.

5-80

Starting and driving