Black plate (165,1)
Model "S51-D" EDITED: 2008/ 3/ 26
Push the ignition switch to the OFF posi-
tion, and then push the
button on the
Intelligent Key. The driver
’
s seat, steering
wheel and outside mirrors will move to the
memorized position or to the exit position
when the entry/exit function is set to
active.
Confirming memory storage
.
Push the ignition switch to the ON
position and push the SET switch. If the
main memory has not been stored, the
indicator light will come on for approxi-
mately 0.5 second. When the memory
has stored in position, the indicator
light will stay on for approximately 5
seconds.
.
If the battery cable is disconnected, or
if the fuse opens, the memory will be
canceled. In this case, reset the desired
position using the previous procedure.
.
If optional Intelligent Keys are added to
your vehicle, the memory storage pro-
cedure to switch 1 or 2 and linking
Intelligent Key procedure to a stored
memory position should be performed
again for each Intelligent Key. For
additional Intelligent Key information,
see
“
KEYS
”
earlier in this section.
Selecting the memorized position
1. Move the selector lever to the P (Park)
position.
2. Use one of the following methods to
move the driver
’
s seat, the outside
mirrors and the steering wheel.
.
Push the ignition switch to the ON
position and push the memory
switch (1 or 2) fully for at least 1
second.
.
Within 45 seconds of opening the
driver
’
s door, push the memory
switch (1 or 2) fully for at least 1
second.
The driver
’
s seat, steering column and
outside mirrors will move to the mem-
orized position or to the exit position
when the entry/exit function is set to
active with the indicator light flashing,
and then the light will stay on for
approximately 5 seconds.
SYSTEM OPERATION
The automatic drive positioner system will
not work or will stop operating under the
following conditions:
.
When the vehicle speed is above 4 MPH
(7 km/h).
.
When the adjusting switch for the
driver
’
s seat and steering column is
turned on while the automatic drive
positioner is operating.
.
When the memory switch 1 or 2 is not
pushed for at least 1 second.
.
When the seat, steering column and
outside mirrors have already been
moved to the memorized position.
.
When no position is stored in the
memory switch.
.
When the engine is started while
moving the automatic drive positioner.
.
When the AT selector lever is moved
from the P (Park) position to any other
position. (However, it will not be
canceled if the switch is pushed while
the seat and steering column are
returning to the previous positions
(entry/exit function).)
.
When the driver
’
s door remains open
for more than 45 seconds and the
ignition switch is not in the ON posi-
tion.
.
The seat synchronization function is
automatically disabled if the outside
mirrors or steering wheel reaches its
maximum adjustment.
Pre-driving checks and adjustments
3-27